Table of Contents
Advertisement
9. Align the drive cage pivot pin with the slot 1 in the upper drive cage and
slide the drive cage with the new hard disk drive installed into the chassis.
10. Connect the signal cable and the power cable to the rear of the new hard disk
drive. See "Connecting a SATA drive" on page 30.
11. Press down on the metal latch 2 and pivot the drive cage into place, and
then slide it to the front of the computer until it snaps into position.
Note: There are two arrows, one on the hard disk drive cage and one on the
upper drive cage. The arrows are aligned when the hard disk drive is in
the proper position.
Figure 25. Installing the hard disk drive
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the replacement, go to "Completing the parts replacement" on
page 35.
Chapter 2. Installing or replacing hardware
33
Advertisement
Table of Contents
