Disc Handling & Maintenance
Disc Handling & Maintenance
Handling Precautions
•
Hold the disc by the edges
so the surface will not be
soiled with fi ngerprints.
•
Fingerprints, dirt and
scratches can cause
skipping and distortion.
•
Do not write on the label
side with a ball-point pen or
other writing utensil.
•
Do not use record cleaning
sprays, benzine, thinner, static electricity
prevention liquids, or any other solvent.
•
Be careful not to drop or bend the disc.
•
Do not install more than one disc on the disc tray.
•
Do not try to close the disc cover when the disc is
not installed properly.
•
Be sure to store the disc in its original case when
not in use.
If the surface is soiled
•
Wipe gently with a soft,
damp (water only) cloth.
•
When wiping discs, always
move the cloth from the
center hole toward the outer
edge. (If you wipe the disc
using a circular motion,
circular scratches are likely
to occur, which will cause
noise.)
Troubleshooting the Optional Tuner
SYMPTOM
Angle cannot change.
No picture with tuner
Picture quality poor with
tuner
REMEDY
• Depends on software availability. Even if a disc has a number of angles recorded, these
angles may be recorded for specifi c scenes only.
• Make sure the antenna and tuner are connected.
• Make sure Tuner is selected as the signal source by pressing the
Tuner
Tuner is selected as the signal source by pressing the
• Make sure Cable / Antenna is set to match the source of the signal by pressing the Menu
button in Tuner mode.
• Make sure the antenna connections are correct and that the Tuner support pin is also
connected.
• Adjust the antenna position for better picture
• Move the DVD player away from any interfering device.
If the disc is brought from a cold to a warm
environment, moisture may form on the disc
•
Wipe moisture off with a soft, dry, lint-free cloth
before using the disc.
Improper disc storage
You can damage discs if you store them in the
following places:
•
Areas exposed to direct sunlight
•
Humid or dusty areas
•
Areas directly exposed to a heat outlet or heating
appliance
Disc which cannot be played with this player
•
CD-ROM (Application Program)
•
CVD
•
CD-G
•
DVD with a Region Code other than that shown
on the DVD unit's Region Code Label on the rear
panel
Maintenance
•
Be sure to turn the unit off and disconnect the AC
power cord before maintenancing the unit.
•
Wipe this unit with a dry soft cloth. If the surfaces
are extremely dirty, wipe clean with a cloth which
has been dipped in a weak soap-and-water
solution and wrung out thoroughly, and then wipe
again with a dry cloth.
•
Never use alcohol, benzine, thinner, cleaning fl uid
or other chemicals. And do not use compressed
air to remove dust.
31
Mode button.