Table of Contents
Advertisement
Installation
Permanent connection
In the case of a permanent connection it is necessary that you install a
double pole switch between the appliance and the electricity supply
(mains), with a minimum gap of 3 mm between the switch contacts and
of a type suitable for the required load in compliance with the current
electrical regulations.
The switch must not break the yellow and green earth cable at any
point.
This operation must be performed by a qualified electrician.
Important: The power supply cable must be easily accessible after
installing the machine.
Door reversal
The opening direction of the outer door on this machine can be rever-
sed. To carry out this operation, proceed as follows:
Disengage the end of the
catch (1) from the door
and turn it 90° to
remove it from its seat
(Fig. A).
Using a screwdriver, turn
plastic plug (2) 90° to
remove it from its seat
(Fig. A).
Fit plug (2) in the hole
left free by catch (1) and
turn it 90° to lock it in
place (Fig. B).
Fit catch (1) into the
hole from which plug (2)
was removed and turn it
90°, making sure that
the latching tooth is fac-
ing towards the right
(Fig. B).
Remove the door by
unscrewing the screws
securing it to the bottom hinge (3 - Fig. A).
42
Advertisement
Table of Contents
