Setting Up The Laminator; Need Help - Fellowes Titan 125 Instructions Manual

SETTING UP THE LAMINATOR

1.
Place the machine on a stable surface. Ensure enough
clear space behind the machine to allow items to pass
through freely.
2.
Connect the supplied power cord to the machine.
STEPS TO LAMINATE
5.
Switch the power on (Power switch located at the rear
of the machine).
6.
Select the 'Standby' button on the control panel. The
3 Mil. and ready LED's will flash for 5 seconds before
automatically selecting the 3 Mil. heat setting. Any
setting can be selected at any time as required. Allow
the machine to cool before opening.
The LED interface allows selection of these functions:
- 3, 4, 5, 7, 10 Mil. pouch settings
- Manual laminating
- Reverse
- 'Easy-Access' for cleaning and maintenance.
7.
The laminator will automatically select the thinnest
pouch setting (3 Mil.) within 5 seconds of power-on
unless another setting is selected. During warm-up or
cool-down, the selected pouch setting will flash red.
8.
When the laminator has reached the chosen setting, the
LED will stop flashing and glow red. The machine will
sound 2 short alerts.

NEED HELP?

Let our experts help you with a solution.
Customer Service:
Always call Fellowes before contacting your place of purchase.
See back cover for useful telephone numbers.
6
www.fellowes.com
3.
Plug the machine into an easily accessible main socket.
4.
To fully support pouches and items of different sizes
use the adjustable entry guide to center the item
before laminating. Place exit tray onto the rear of the
machine.
9.
Place item into open pouch. Center the item against
the sealed front edge. Use the appropriate pouch size
for the item.
10.
Place the pouch, sealed edge first into the document
entry. Keep the pouch straight and centered within the
document entry, not on an angle. Use the entry mark-
ings as a guide.
11.
Upon exit, the laminated pouch is hot and soft. Take
care and remove the pouch immediately. Place the
pouch onto a flat surface to cool. This helps prevent any
jamming.
12.
To reverse the laminating process at any stage, press
and hold the 'Reverse' button to eject the item. The
laminator will sound alerts continuously and the ready
LED will flash.