BT ON-AIR 1000 User Manual page 5

Setting up
Please note that your handset must be registered to
the base before use.
Situate your product close enough to the mains power
sockets so that the cables will reach.
Make sure it is at least 1 metre away from other
electrical products to avoid interference.
Do not situate the product in the bathroom or other
humid areas.
Under no circumstances should non-rechargeable
batteries be used. Only use the approved batteries.
Using unapproved batteries will invalidate your
warranty and may damage the telephone.
Fully discharging the batteries at least once a week
will help them to last as long as possible. However,
the charge capacity of rechargeable batteries will
reduce with time as they wear out, so reducing the
talk/standby time of the handset. Eventually
they will need to be replaced. New batteries can
be obtained from any BT Shop or from the
helpline on 0845 601 2476.
Slide off the battery cover and install the battery.
Replace the battery cover.
When the battery has been charged for at least 16
hours the display will show the
then connect the telephone line cord to the base.
If the handset battery symbol is empty and you hear
warning beeps, you will need to recharge your
handset before you can use it.
Your handset is supplied with NiMH batteries. These
need to be initially charged continuously for 16 hours
to reach full charge.
Note that the battery charge icon does not indicate
the correct level when the batteries are first installed.
The batteries must first be fully charged.
If you are experiencing difficulty, please call the BT
On-Air Helpline on
symbol; you can
.
4