Advertisement
Metal
Detectors
the detector into Beach mode. In Beach mode
the detector will ignore Iron.
All Metal Mode (VK30 only)
The All Metal mode works by producing a faint
threshold tone. This will only be heard when
headphones are used. As the search head
moves over a metal object the volume of this
tone increases and is at a maximum when the
centre of the head is directly above the object.
Problem
No sound from speaker
Unit does not detect targets
False Signals
Continuous tone from speaker
If you are experiencing any problems not covered by the above see page 6 for details of our
warranty / repair service.
5
This feature can be used in two ways. The
detector can be used in motion mode as
previously described. When an object is found
the push button can be held in to pinpoint an
object. If the threshold tone drifts, release and
repress the button to retune the detector.
An alternative method of use is to search in All
Metal mode as selected by the discrimination
control. The push button can be used to retune
the detector if drift has occurred by pressing and
releasing it. Alternatively, holding in the button
will switch the detector to motion mode for
accurate discrimination.
Possible Cause
Battery
Headphones connected
Sensitivity too low
Discrimination too high
Cable detection
Noisy conditions
Heavily mineralised ground
conditions
Detector not tuned to threshold
(VK-30 Only)
1 Angela Street
Mill Hill, Blackburn
BB2 4DJ
t:
+44 (0)1254 55887
f:
+44 (0)1254 676901
e:
viking@metaldetectors.co.uk
Remedy
Check battery is good &
inserted correctly
Remove headphones
Increase sensitivity
Decrease discrimination
Wrap cable snugly round shaft
Reduce sensitivity
Increase discrimination
Reduce sensitivity
Press retune button / Switch to
motion mode
www.metaldetectors.co.uk
Advertisement
