Inserting A Disc; Removing A Disc; Emergency Eject - AOpen DRW8800 AAN User Manual

Dvd±rw dual drive
Table of Contents

Advertisement

---------------------------------------------------------------------------------------------

Inserting a Disc

1. Press the Load/Eject button. The disc tray will be ejected.
2. Place the disc in the center of the tray with the label side facing up.
3. Press the Load/Eject button. The disc tray will be retracted.

Removing a Disc

1. Press the Load/Eject button. The disc tray will be ejected.
2. Remove the disc.
3. Press the Load/Eject button. The disc tray will be retracted.
WARNING:
Do not forcibly push the disc tray in by hand. Doing so may result in damage.
Note:
If an eject prohibit command has been received from the computer, the disc tray will not be ejected even
if the Load/Eject button is pressed.

Emergency Eject

The procedure described below can be used to remove a disc from the DVD R/RW drive if the Load/Eject
button is disabled by software or a power failure occurs.
1. Turn off the power to the computer installed the DVD R/RW drive.
2. The disc that is inside may still be spinning. Please wait 1minute until it stops to spin certainly.
3. Insert a steel rod as paper clip and so on that is straightened (about 1.3mm in diameter) into the
emergency eject hole and push slowly. The disc tray is ejected by about 1cm. Pull it all the way open by
hand.
- 13 -

Advertisement

Table of Contents
loading

This manual is also suitable for:

Drw8800 aag

Table of Contents