Channel Settings - Philips PFL7xx7G User Manual


[Screen format]: Access advanced
settings to control the display format of
the picture.
- [Picture format]: Change the
picture format.
- [Screen edges]: Change the
picture size.
More sound settings
You can change the settings in the Sound
menu.
1. Press .
2. Select [Setup] > [TV settings] > [Sound],
then press OK.
3. Select a setting to change, then press OK:

[Sound style]: Access predefined sound
settings.

[Bass]: Adjust the bass level of the
speaker and headphones.

[Treble]: Adjust the treble level of the
speaker and headphones.

[Balance]: Adjust the volume of the left
and right speakers.

[Surround mode]: Select a surround
sound mode to enhance your audio
experience.

[Auto incredible surround 3D]: Select
a surround sound mode to enhance
your audio experience in 3D mode.
Only available on PFL6xx7G and
PFL7xx7G.

[Headphone volume]: Adjust
headphone volume.

[Advanced]: Access advanced settings
to enhance your audio experience.
- [Auto volume leveling]: Enable
the reduction of sudden volume
changes, for example, when switching
channels.
- [TV speakers]: Select the
preferred speakers to stream audio
from the TV. See Use more of your
TV > Use EasyLink > Select speaker
output (Page 37).
EN 40
- [Clear sound]: Enhance sound
quality.
- [Digital output format]: Select
the type of audio output through the digital
audio output connector. Select between
audio formats of [Multichannel] or [Stereo].
- [Digital output level]: Set the
sampling rate for stereo audio. Select [Low]
for a certain amount of loss in intensity or
signal strength. Select [Normal] for no loss
in intensity or signal strength.
- [HDMI1 - audio out]: Enable
audio output from the device connected to
the HDMI 1 connection.
- [Audio out delay]: Automatically
sync the image on the TV to the audio from
a connected home theater.
- [Audio out offset]: Adjust the
setting for audio output delay. This option is
available only if [Audio out delay] is
switched on.
Reset picture and sound
You can restore the default picture and
sound settings, while the channel installation
settings remain the same.
1. While you watch TV, press .
2. Select [Setup] > [TV settings] > [General
settings] > [Factory settings], then press
OK.
All TV settings (except for channel settings)
are reset to the default factory settings.

Channel settings

Automatic install
When the TV was switched on for the first
time, a full installation of channels was
performed. To change your language,
country, and reinstall all available TV
channels, you can run this full installation
again.