1. Manuals
  2. Brands
  3. Jumpking Manuals
  4. Enclosure
  5. Fun Ring
  6. User manual

Jumpking Fun Ring User Manual

Tramploline enclosure system
Hide thumbs
1
2
3
4
5
6
7
Table of Contents

Advertisement

Quick Links

Download this manual
CONTENTS

Important Precautions . . . . . . . . . . 2

Warning Placard Placement . . . . . .3

Before You Begin . . . . . . . . . . . . . 4

Trampoline Enclosure Safety
Information . . . . . . . . . . . . . . . . . . 4
Assembly . . . . . . . . . . . . . . . . . . . 6
Care And Maintenance . . . . . . . . 10
Limited Warranty . . . . . Back Cover
QUESTIONS?
If you have questions after reading
this manual, please call our toll-free
Customer Hot Line. The trained
technicians on our Customer Hot Line
will provide immediate assistance.
Customer Hot Line: 1-800-322-2211
Monday–Friday, 8 a.m.–5 p.m. MST
REPLACEMENT
PARTS
www.jumpking.com
WARNING
Read the assembly, installation,
care, maintenance, and use
instructions in this manual prior
to assembling and using this
trampoline enclosure. Save this
manual for future reference.
Trampoline Enclosure System
USER'S MANUAL
www.jumpking.com
Visit our Web site at
(Packet Part No. 80-00038)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Fun Ring and is the answer not in the manual?

Questions and answers

Summary of Contents for Jumpking Fun Ring

  • Page 1 Customer Hot Line will provide immediate assistance. Customer Hot Line: 1-800-322-2211 Monday–Friday, 8 a.m.–5 p.m. MST REPLACEMENT PARTS www.jumpking.com WARNING Read the assembly, installation, Visit our Web site at care, maintenance, and use instructions in this manual prior to assembling and using this www.jumpking.com...
  • Page 2 ASSEMBLY IMPORTANT ASSEMBLY INFORMATION TRAMPOLINE PLACEMENT • Assembly requires a 9/16” socket and ratchet (or 1. Place the trampoline and enclosure on a level a 9/16” open-end wrench) and a Philips screw- surface before use. driver (not included). 2. Adequate overhead clearance is essential. A •...
  • Page 3 2. Lay two Straight Tubes (6), two L-tubes (7), and a Curved Tube (8) on the ground so they form an arch. Make sure that the Straight Tubes are orient- Small Hole ed so the small holes are in the positions shown. Slide a Foam Sleeve (9) onto each of the five Tubes;...
  • Page 4 4. Spread the Netting (10) on the trampoline bed, with the door of the Netting below the Curved Tube (8) where jumpers will climb onto and off the trampoline. Next, locate one of the D-rings attached to the upper edge of the Netting. Lift the D-ring and hold it near an L-tube (7) as shown.
  • Page 5 7. When the last Cord (13) reaches the strap below the door, thread the Cord over the strap, through Door the nearest V-ring, over the strap again, and through the V-ring again. Do not thread the Cord Strap through the lower edge of the door. Pull the Cord tight.
  • Page 6 Foam Sleeve ORDERING REPLACEMENT PARTS To order replacement parts, visit our Web site at www.jumpking.com or call our toll-free Customer Hot Line at 1-800-322-2211, Monday through Friday, 8 a.m. until 5 p.m. Mountain Time (excluding holidays). To help us assist you, please provide the following information when calling: •...

  • Page 7: Limited Warranty

    JUMPKING authorized service center, or to products used for com- mercial or rental purposes. No other Warranty beyond that specifically set forth above is authorized by JUMPKING.

Table of Contents