Preparation; Assembling The Detector; Installing Batteries - Famous Trails MD 7030 Owner's Manual

Discriminator ii
Table of Contents

Advertisement

63-3013.fm Page 4 Wednesday, July 26, 2000 9:42 AM
ˆ

Preparation

ASSEMBLING THE
DETECTOR
Assembling your detector is easy and re-
quires no special tools. Just follow these
steps.
1. Turn the stem's lock
nut clockwise until it
loosens.
2. Lengthen or shorten
the stem so when
you
stand
upright
with the detector in
your hand, the search
coil is level with and
1
about
/
to 2 inches
2
above
the
ground
with your arm relaxed
at your side.
3. Turn the stem's lock
nut counter-clockwise
to lock it in place.
4. Unscrew the knobs
on the search coil
and
remove
the
knobs and connec-
tor. Insert the stem
and align the holes
on the search coil
bracket and the stem.
Push the connector through the holes,
then replace and tighten the knobs.
5. Wind the search coil cable around the
stem. Leave enough slack in the cable
to let you adjust the search coil when
you are hunting on uneven ground.
6. Insert the search coil's plug into the
search coil jack on the detector's control
4
Search
Coil
Knobs
7. Loosen the knob at the search coil's
Stem
Lock Nut
8. Loosen the knob at the base of the han-
Arm

INSTALLING BATTERIES

Support
Your detector requires two 9V alkaline bat-
teries (not supplied) for power.
.
.
Cautions:
• Use only fresh batteries of the required
• Do not mix old and new batteries, differ-
Preparation
housing so the pins on the plug are
aligned with the holes in the jack.
Cautions:
• The search coil's plug fits into the
connector only one way. Do not force
the plug or you could damage it.
• To disconnect the search coil's cable
from the detector, grasp the plug and
pull it out of the connector. Never pull
on the cable.
end, then adjust the search coil to the
desired angle. (The search coil should
be parallel with the ground.) Tighten the
knob just enough to keep the search coil
from rotating or wobbling.
Caution: Do not overtighten the search
coil or use tools such as pliers to tighten
it.
dle, insert the arm support, and tighten
the knob.
size and recommended type.
ent types of batteries (standard, alka-
line, or rechargeable), or rechargeable
batteries of different capacities.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents