Door Reversibility - Electrolux ER 1930 I Installation And Instruction Manual

Door reversibility

Unplug the appliance from the power supply before
carrying out the below-mentioned operations.
Remove the ventilation grill (D).
Unscrew the bottom hinge (E).
Remove the freezer door by releasing it from the mid-
dle hinge (H).
Unscrew the middle hinge.
Remove the fridge door by releasing it from the top
hinge pin (A).
Remove the pin and the washer (A+B) from the top
hinge (C), then mount these on the opposite side.
Remove the two plugs, to reveal the holes for the
hinge pivots, and remount them on the other side.
Refit the fridge door.
Replace the middle hinge to the left hand side.
Replace the freezer door.
Screw down the bottom hinge (E) on the opposite side
by using the screws previously removed.
Remove the plug (F) from the ventilation grill (D) and
replace it on the opposite side.
Re-assemble the ventilation grill (D).
Reverse the direction of the handle.
The holes which are not used are masked by plastic
plugs which should be removed and refitted onto the
free holes.
The doors can be aligned by adjusting both the mid-
dle and top hinges.
The middle hinge can be adjusted horizontally, with
the help of a tool, after having slackened the two
screws.
The top hinge is adjusted by slackening the nut with a
10 mm spanner and then proceeding as shown in the
Figure.
Warning:
After having reversed the opening direction of the
doors check that all the screws are properly tight-
ened and that the magnetic seal adheres to the
cabinet. If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the cabinet.
In that case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part in-
volved with a normal hairdrier.
36
E
F
D
F
D640
D427
D426
H
D405
Fig. 2
F
F
Fig. 3
C
B
A
Fig. 4
Fig. 5