Table of Contents
Advertisement
INSTALLATION
If this appliance featuring magnetic door seals is
to replace an older appliance having a spring lock
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the old
appliance.
This will prevent it from becoming a death-trap for
a child.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct sun-
light etc.; best performance is obtained with ambient
temperature between +16 C and +32 C (class N) or
between +10 C and +32 C (class SN). The class of
your appliance is shown on its rating plate.
For building into kitchen units follow the special
"Building-in" instructions given.
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the serial number plate correspond
to your domestic power supply.
Voltage can vary by 6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a con-
tact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in compli-
ance with current regulations, consulting a specialist
technician.
The Manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio inter-
ference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibil-
ity Directive) and subsequent modifications.
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these
will damage the finish.
32
Instructions for totally built-in appliances
Dimensions of the recess
Model ER 2334 I
Height
1225 mm
Depth
550 mm
Width
560 mm
The appliance's door has been locked in position
for transport by means of pins on both sides. Ac-
cording to the door opening direction, remove rel-
evant pins at the top and at the bottom.
For safety reasons, minimum ventilation must be as
shown in Fig. 1.
Attention: keep ventilation openings clear of ob-
struction.
50 mm
D567
A
D022
A
D265
Model ER 1532 I
Model ER 1632 I
880 mm
550 mm
560 mm
Fig. 1
min.
2
cm
200
Fig. 2
Push appliance in-
to the housing until
stop strip (A) touch-
es the kitchen unit.
Fig. 3
If after having car-
ried out the previ-
ously described op-
eration there is still
some space left be-
tween the appli-
ance and the kitch-
e n u n i t , fit t h e
trimming provided
together with the
appliance on the
stop strip (A).
Advertisement
Table of Contents
