Unpacking Instructions - JEFF ROWLAND 3 Owner's Manual

Unpacking Instructions

In the shipping crate you will find:
--AC Power Cord
--Various Fuses
--XLR Shorting Plugs
--Performance Certificate
--Warranty Card (This form must be completed and returned to JEFF ROWLAND
DESIGN GROUP [or its authorized distributor if outside the U.S.A.] within 14
days of purchase. Not only will your amplifier be registered, but you will, in the
future, be informed of new products and services.
We strongly suggest that you save all packing materials
The amp can be lifted out of its crate while still wrapped in the plastic bag and
surrounded by the protective foam.
Installation
Locate the amplifier as close as possible to its final installation point. Allow access to the
back panel for making connections.
All Jeff Rowland Design Group products are convection cooled, eliminating the need for a
fan. When operating, the amp should have at least 2 inches of space on all sides. It is
acceptable to stack the amplifiers only if fresh air is allowed to circulate around them.
When the amp is in position, the power cord should be inserted first at the inlet on the
amplifier back panel, then connected to an appropriate power source. The amplifier is
equipped with a "stand-by" power switch, located and identified on the rear panel, as
well as an illuminated power push button switch on the front panel. The stand-by power
switch should be turned on initially after plugging in the AC power cord. The amplifier
will now be in stand-by mode, indicated by a dimly lit front panel button. The rear panel
switch should be left on at all times, maintaining stable operating parameters and
thereby improving performance, reliability and longevity. Power consumption in stand-by
mode is less than 25 watts, providing low-cost operation.
Pressing the dimly lit push button will switch the amplifier on for normal operation. Note
that the lamp intensity will increase and a faint "click" will be heard. All subsequent on-
off cycles should be initiated by the front panel switch.
If the front panel switch does not light, the amplifier does not power up or a fuse blows,
disconnect AC power, refer to the troubleshooting section of this manual or contact your
dealer.