Advertisement
HOW TO INSTALL
Location
Install refrigerator in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the refrigerator and side wall so the door will
open for a fully usable interior. Refrigerator is not designed for recessed
installation.
Leveling
Level refrigerator so it rests solidly on the floor without rocking. There are two
leveling glides, one at each front corner. Turn to the left to raise a corner, to the
right to lower it. Use shims under rear corners, if necessary.
If you want, the refrigerator door to close when not held open, adjust glides
§
so that the front of the refrigerator is raised. However, front corners must
be level with each other, and rear corners with each other.
If you want, the refrigerator door to remain motionless when open, adjust
§
the leveling glides so that all four corners are level with each other.
NOTE : Make sure all packing material is removed. If the shipping tape has
left a residue on the door, touch the residue lightly with the
adhesive side of tape or with isopropyl alcohol (most rubbing
alcohol is this type).
Do not use a solvent, such as lighter or cleaning fluid, nor an
abrasive cleanser.
HOW TO CLEAN
Cleaners: The cleaners noted below are available.Never use harsh, abrasive
cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains
and for periodic waxing, use silicon wax.
Freezer chest: When refrigerator needs defrosting set TEMPERATURE
CONTROL at OFF. Do not use sharp instruments.
Refrigeration Section: Wash shelves drawers and other removable parts in
warm sudsy water, rinse and dry. Wash interior with
baking soda solution (3 Table spoons to one quart of
water) or warm sudsy water.
Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return TEMPERATURE
CONTROL to desired setting.
3
HOW TO OPERATE
1. TEMPERATURE CONTROL
Temperature is controlled automatically. The TEMPERATURE CONTROL at
the front side of the refrigerator section determines the amount of cooling
your appliance receives.
To start refrigerator
Set TEMPERATURE CONTROL at MED.
To change temperature
Many factors influence the internal temperature of the refrigerator section
and freezer section.
The temperature and humidity of the home.
§
The frequency of door openings and the amount of warm food placed in
§
the refrigerator.
The combination of foods and containers stored in the refrigerator
§
For these reasons, you may want to adjust the control to suit the season
and your needs. When adjusting the temperature:
Turn TEMPERATURE CONTROL toward PULL DOWN for colder
§
temperature in refrigerator and freezer sections, and toward MIN for
warmer temperature in both sections.
Allow approximately 12 hours or overnight for temperature to stabilize.
§
Then check to see if further adjustments are necessary.
To turn off refrigerator
Disconnect the power supply cord. Remove ice tray and food. Leave
doors ajar for air circutation and dehumidification of both sections.
4
Advertisement
