SWL remote control for ICOM Operating Manual page 7

Radio Power
Power Radio power on /off. This only works on ICOM Transceivers if the
command is implemented in the CI-V interface on that radio.
Direct Entry of Frequencies (Examples)
0 8 3 0 Enter
0 Mute 7 Enter
5 0 0 Mute Enter
3 Mute 2 5 9 Enter
1 5 Mute Enter
1 5 Mute 2 3 Mute 5 Enter
1 5 2 3 5 Enter
9 5 6 5 Enter
3 Mute 5 Enter
Mute (Mute) (Mute)
Frequency and Memory Channel stepping
VFO Mode
CH+ Freq+ by tuning step
CH- Freq- by tuning step
Tuning Steps
x before CH+/- to set a tuning step. It stays until changed again.
1 1Hz
2 10Hz
3 100Hz
4 1kHz
5 5kHz
6 10kHz
7 100kHz
8 1MHz
9 9kHz
User Tuning Steps
0 before CH+/-
0 x before CH+/-
Scan Control
VFO Mode
Last Start/Stop Programmed Scan
Copyright © 2003, 2004, 2005 by swl-remotes.com,
Universal Remote Commands
830kHz
700kHz
500kHz
3259kHz
15000kHz
15230.5kHz
15235kHz
9565kHz
3500kHz
Clear key entry during numeric entry. LED will blink twice.
Memory Mode
Memory+
Memory-
Last Used User Tuning Step
User Tuning Step (x=1, 2, 3, 4, 5)
Memory Mode
Start/Stop Memory Scan
7
All rights reserved.