Table of Contents
Advertisement
5)
Before replacing the battery cover, check the rubber seal located on the under
side of the cover: make sure that the seal is set in the groove and that there is no
foreign matter under the seal.
If the rubber seal appears warn, nicked, or dried out, you must replace it.
New seals are available through the Parts Department (see our website for
contact information).
6)
Replace the battery cover; use the four screws to secure the cover to the back of
the handset.
Rechargeable nickel-Metal-Hydride Battery Warning
CAUTION! Risk of explosion if battery is replaced by an incorrect type!
Dispose of used batteries according to the instructions. Do not open or
mutilate the battery. Disconnect the battery before shipping this product.
This equipment contains a rechargeable Nickel-Metal-Hydride (Ni-MH) battery.
Do not short-circuit the battery.
The rechargeable battery contained in this equipment may explode if disposed of in a fire.
Do not charge the battery used in this equipment in any charger other than the one
designed to charge this battery as specified in the owner's manual. Using another charger
may damage the battery or cause it to explode.
Rechargeable batteries must be recycled or disposed of properly.
Uniden works to reduce lead content in PVC coated cords in our products and
accessories.
IMPORTAnT Satisfactory evidence of the original purchase is required for warranty
service
Please refer to our Uniden website for any details or warranty durations offered in addition to those contained below.
Warrantor
The warrantor is either Uniden Australia Pty Limited ABN 58 001 865 498 ("Uniden Aust") or Uniden New Zealand
Limited ("Uniden NZ") as the case may be.
Terms of Warranty
Uniden Aust/NZ warrants to the original retail purchaser only that the XDECT 7005 WP ("the Product"), will be free from
One-Year limited Warranty
6
Advertisement
Table of Contents
