Table of Contents
Advertisement
10 START/PAUSE button
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the machine. The light above the button will stop
flashing and remain lit.
If you have selected a delay time by means of
button 12, the countdown will begin and will be
shown on the display.
• Pause: when you press this button again, the
programme in progressis interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, the DOOR LOCKED
light goes out, and it becomes possible to open the
door, provided
• the machine is not in the heating or drying phase;
• the level of the water is not high;
• the drum is not turning.
Important!
You must set the machine to PAUSE before you
make any change in the programme in progress.
11 SKIP/RESET button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the machine on, the blinking zero will reappear and
the audible warning signals relevant to the end of the
previous cycle will be given.
You can also press the SKIP/RESET button to
exclude one or several phases of the programme
which is running, as indicated below.
- set the machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the SKIP/RESET button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the name of the phase(s) will go
out).
Example:
This button allows you also to select special
programmes, such as
(drain).
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress SKIP/RESET once or repeatidly to cancel
the previously performed programme;
- select the type of fabric by means of FABRICS
button;
- select the special programme:
•
(RINSES)
Depress SKIP/RESET once, the pilot light
(WASH) goes out.
•
(SPIN)
Depress SKIP/RESET twice, the pilot lights
(WASH) and
(RINSES) go out.
•
(DRAIN)
Depress SKIP/RESET three times, the pilot lights
(WASH),
(RINSES) and
and only the pilot light
Example:
13
In this case, both the
drain and the spin (at the
speed provided for the
selected type of fabric)
will be performed.
(rinses),
(spin) and
(SPIN) go out,
will light on .
In this case the machine
will perform the rinses
followed by the spin.
Advertisement
Table of Contents
