Installation - Harman Kardon The Bridge III Owner's Manual

InstallIng
With only a single cable connection, The Bridge III is
easy to connect to your Harman Kardon product.
step One: Turn off the Harman Kardon The Bridge
III-ready product, using its main power switch.
step two: Holding the cable with the wider part of
the connector at the bottom, gently squeeze the tabs
on each side as you insert it into the connector on the
rear panel of the Harman Kardon product. See Figure 1.
Figure 1 – The Bridge III connector.
step three: Place the black insert in The Bridge III,
making sure to push it all the way down. See Figure 2.
nOtE: Do not place an iPod or iPhone in The Bridge
III unless both the black insert and a dock adapter
are installed. Otherwise, the iPod or iPhone will not
connect properly, and both it and the Bridge III may
sustain damage that is not covered by the warranty.
table 1 – select the Correct the Bridge III Insert
The Bridge III Insert
NANO
5G (VIDEO 60GB)
5G (VIDEO 30GB)
13
12, 14
iPod Model
iPod nano, 1st and 2nd generation
iPod, 5th generation (60GB, 80GB) and iPod classic (160GB)
iPod, 5th generation (30GB) and iPod classic (80GB)
iPod nano, 3rd and 4th generation
iPod touch – install large bumper;
iPhone and iPhone 3G – install small bumper

InSTALLATIOn

step Five
step Four
step three
step Four: Locate the dock adapter that was
included with your iPod or iPhone, or select one of the
included clear dock adapters by referring to Table 1. If
your iPod or iPhone does not appear in Table 1 and did
not include an adapter, contact Apple Inc. to purchase
one.
Place the adapter in The Bridge III insert, as shown
in Figure 2.
step Five: Remove the iPod or iPhone from any
case, and dock it in The Bridge III, as shown in
Figure 2.
Figure 2 –
Docking an iPod or
iPhone in The Bridge III
3