Harman Kardon SB 30 Owner's Manual page 5

SB 30
Soundbar Top-Panel Controls
Power Surround
Button Mode
and Button
Power
LED
Power button: When the soundbar is in the Standby mode (the Power LED is amber),
pressing the Power button will turn on the soundbar. When the soundbar is on (the Power
LED is blue), pressing the Power button will put it into the Standby mode.
Power LED: The Power LED will display different colors and patterns to indicate the
soundbar's status:
• Power LED is constantly blue: The soundbar is on.
• Power LED is flashing blue: The soundbar is muted.
• Power LED is amber: The soundbar is in the Standby mode.
• Power LED is off: The soundbar is off.
Surround Mode button: Pressing the Surround Mode button cycles the soundbar's audio
output through the following three surround modes: Stereo > Virtual > HARMAN Wave >
Stereo, etc. The active surround mode is indicated by the soundbar Status LEDs (see
Soundbar Status LEDs , below). See Surround Modes , on page 11, for information about
the surround modes.
Volume Down/Up buttons: Press the "–" button to decrease the volume; press the "+"
button to increase the volume.
Source Selector button: Pressing the Source Selector button changes the active input
source among the Optical Digital, Coaxial Digital and Analog input connectors. The active
input source is indicated by the soundbar Status LEDs (see below).
Dolby Volume button: Pressing the Dolby Volume button cycles the Dolby Volume
®
setting between off, low and high. The active setting is indicated by the soundbar Status
LEDs (see below). See Dolby Volume , on page 12, for more information about Dolby
Volume.
Volume Source Dolby
Down/Up Selector Volume
Buttons Button Button
Soundbar Status LEDs
The soundbar has three LED indicators located behind the grille, as shown in the
illustration below.
Status
LEDs
The status LEDs light up in different colors and numbers to indicate the following:
Active input source (white LEDs)
1 LED = Optical Digital Input
2 LEDs = Coaxial Digital Input
3 LEDs = Analog Input
Active surround mode (blue LEDs)
1 LED = Stereo mode
2 LEDs = Virtual surround mode
3 LEDs = Wave surround mode
(See Surround Modes , on page 11, for information about the surround modes.)
Room Size setting (green LEDs)
1 LED = Small room
2 LEDs = Medium room
3 LEDs = Large room
(See Surround Modes , on page 11, for information about the Room Size setting.)
Dolby Volume setting (red LEDs)
1 LED = Off
2 LEDs = Low
3 LEDs = High
(See Dolby Volume , on page 12, for information about Dolby Volume.)
NOTE: The Status LEDs will turn off after five seconds of no button presses.
Connections and Controls
5