Advertisement
ASSEMBLY INSTRUCTIONS:
I-ATTACH #9, L.H. BRACKET, TO THE TRACTOR USING PARTS #17, 22,
23 & 24.
REPEAT FOR #8, R.H. BRACKET.
MOUNTING HOLES IN THE
TRACTOR ARE LOCATED MIDWAY AND A LITTLE FORWARD ON EACH SIDE.
2-PLACE #7, LIFT BRACKET, UNDER TRACTOR AND POSITION THE SLOTS
UNDER THE PINS ON BRACKETS 8 AND 9.
SECURE IN PLACE WITH #11,
CLEVIS PINS, AND INSERT ONE #10, SAFETY PIN, THROUGH EACH
CLEVIS PIN HOLE.
3-POSITION #5, MOUNTING BRACKET, WITH ALREADY INSTALLED LIFT
BRACKET, AND HANG IN PLACE WITH #14, LIFT LINKS, AS SHOWN.
INSERT ONE #10, SAFETY PIN, THROUGH EACH LINK HOLE.
4-ATTACH #2, BLADE BRACKET, TO #1, BLADE, USING PARTS #18, 19
&
20.
TIGHTEN NUTS SECURELY.
ONCE THE BRACKET IS ATTACHED
TO THE BLADE, IT IS UNNECESSARY TO EVER REMOVE IT.
S-PLACE #4, TUBE, IN POSITION WITH HOLES IN #2, BLADE BRACKET,
AND INSERT #21, PIN, THROUGH HOLE.
INSERT ONE #13 SAFETY
PIN.
6-ROTATE INSTALLED BLADE ASSEMBLY TO DESIRED ANGLE AND DROP #3,
ANGLE CONTROL ROD, IN HOLES.
INSERT ONE #10, SAFETY PIN,
THROUGH EACH HOLE.
7-TO ATTACH #30, LIFT LEVER AND ROD ASSEMBLY, PLACE HOLE IN THE
END OVER EXPOSED END OF SHAFT AND POSITION SO THAT THE LEFT
EDGE OF THE QUADRANT SLIPS THROUGH THE SPACE RETAINING THE
SPRING LOADED LIFT ROD.
WHEN IT IS IN IT'S FARTHEST POSITION
ROTATE TO THE RIGHT UNTIL THE PIN HOLES ALIGN WITH EACH OTHER.
DRIVE #25, PIN, THROUGH HOLES.
INSERT #31, HEX BOLT, THROUGH
HOLE AND LOCK WITH #32, NUT.
INSERT #12, ADJUSTING SCREW, AND
LOCK IN PLACE WITH #17, NUT.
8-TO ATTACH THE RAKE ATTACHMENT, MODEL NO. 235-26424, NO BRACKET
IS REQUIRED.
SIMPLY PLACE #4, PIVOT TUBE, IN POSITION WITH RAKE
AS SHOWN IN EXPLODED VIEW OF PARTS.
SECURE WITH #21, CLEVIS PIN,
AND #13, SAFETY PIN.
SET DESIRED ANGLE OF RAKE AND DROP #3,
ANGLE CONTROL ROD IN HOLES.
INSERT ONE #10, SAFETY PIN IN EACH
HOLE.
OPERATING INSTRUCTIONS
I-PULL THE LIFT LEVER BACK UNTIL THE ROD FALLS INTO THE SLOT TO
HOLD IN UP POSITION.
ALL THE WAY FORWARD DROPS THE BLADE TO
GROUND LEVEL.
2-GRADER BLADE GROUND HEIGHT CAN BE CHANGED BY ADJUSTING #12,
HEIGHT ADJUSTING SCREW.
CLOCKWISE RAISES THE BLADE, COUNTER
CLOCKWISE LOWERS IT.
3-CHANGING THE ANGLE OF THE BLADE IS ACCOMPLISHED BY SELECTING
THE RIGHT HOLE IN #5, MOUNTING BRACKET, AND LOCKING IN POSITION
WITH #3, ANGLE CONTROL ROD.
4-TO ROTATE THE BLADE, ADJUST #6, ADJUSTING SCREW, UNTIL SUITABLE
GRADE IS OBTAINED.
Advertisement
