Table of Contents
Advertisement
32 electrolux installation
Fitting under a counter (kitchen
worktop or sink)
Remove all packaging before position-
ing the machine.
If possible, position the machine next to
a water tap and a drain.
By removing the machine's worktop,
you can install it under a close fitting sink
unit or a pre-existing top, providing the
dimensions of the recess correspond to
those shown in the picture.
Proceed as follows:
• Remove the machine's worktop by
unscrewing the two rear retaining
screws, pull the worktop from the
back of the machine and slide out the
front slots, lifting the worktop.
Insert the machine after adjusting the
levelling with the adjustable feet. When
inserting the machine, ensure that the
water inlet and drain hoses are not
kinked or squashed.
During all operations that involve
accessibility to internal components the
dishwasher has to be unplugged.
Be sure that once the appliance has
been installed, it is easily accessible for
the service engineer in the event that a
repair is required.
If the dishwasher is later used as a free-
standing appliance, the original worktop
must be re-mounted.
The plinth on free-standing appliances is
not adjustable.
Levelling
Good levelling is essential for correct
closure and sealing of the door.
When the appliance is correctly levelled,
the door will not catch on either side of
the cabinet .
If the door does not close correctly,
loosen or tighten the adjustable feet until
the machine is perfectly level.
Advertisement
Table of Contents
