Levelling; Door Reversal - Electrolux EU 1341 T Instruction Book

Hide thumbs Also See for EU 1341 T:

Table of Contents

Levelling

The appliance must be level. Level the appliance by

adjusting the two adjustable feet (1) at the front of the

appliance.

If required the washer (2) can be removed.

If required the opening direction of the door can be

changed as follows:

Disconnect the appliance from the electricity

supply.

Tilt the appliance backwards, resting the top edge

of the appliance on a stool or something similar.

Unscrew the adjustable feet situated on both sides

at the front (2 pieces). Remove the lower door

hinge plate by unscrewing the 3 retaining screws.

Remove the hinge pin from the bottom of the door.

Slot the hinge pin into the hole in the hinge plate.

Take the door off.

Refit the upper hinge pin into the opposite location.

Fit the door in place on the hinge pin.

Slot the hinge pin into the hole in the hinge plate

and relocate the hinge assembly to the opposite

location and refit using the retaining screws.

Refit the bottom hinge plate assembly on the

opposite side, taking care that the edge of the door

is parallel with the side of the cabinet.

To reverse the handle proceed as follows:

Remove screw covers (if fitted) and handle retaining

screws. Remove blanking plugs on the opposite

side using a punch .

Relocate the handle to the opposite side and refit

retaining screws (covers if fitted), and push the

plastic plugs supplied with the instruction book into

the holes where the handle was previously fitted

Table of Contents