3. Place an oil pan under the final gear case to
collect the used oil.
4. Remove the final gear oil filler bolt, the final
gear oil drain bolt and their O-ring to drain the
oil from the final gear case.
1. Final gear oil drain bolt
2. O-ring
5. Install the drain bolt and its new O-ring, and
then tighten the bolt to the specified torque.
Tightening torque:
Final gear oil drain bolt:
24 Nm (2.4 m·kgf, 17 ft·lbf)
1
6. Refill with the recommended final gear oil to
the brim of the filler hole as shown. NOTICE:
Be sure no foreign material enters the final
gear case.
1
1 2
2
3
4
1. Final gear oil filler bolt
2. O-ring
3. Final gear oil
4. Correct oil level
Recommended final gear oil:
See page 10-1.
TIP
If the recommended oil is not available, SAE80W-
90 API GL-5 Hypoid gear oil may be used instead.
8-17
[ECB00421]
8