Advertisement
How to Set up the ASP16
STEP 1: Please note that the battery in ASP16 is expected to lose some
charge in shipping and storage. It will recharge completely in
approximately 4 hours of normal operation. Do not expect full
battery run time during this charging period.
STEP 2: Plug the ASP16 into an electrical outlet that does not share circuit
with heavy electrical loading (e.g. air conditioner, refrigerator, etc.)
If "wiring OK" light does not light up, refer to page 3, item #3.
STEP 3: Plug your DVR power cord into the ASP16 UPS protected outlet.
(Not Suitable for Camera Power Supplies.)
STEP 4: Connect the coaxial cable runs from cameras to the "IN" connectors
on the ASP16. Attach patch cords of at least 3 feet in length
to the "OUT" connectors on the ASP16 and then to the feed
ports on your DVR.
STEP 5: Connect the incoming 100 Base-T line to the "IN" jack on the
ASP16 marked "Cat. 5" Connect patch cord at least 3 feet in
length between the "OUT" jack and your DVR.
STEP 6: Connect your incoming phone/fax/modem line to the ASP16
jack marked "RJ45 IN". Use a patch cord of at least 3 feet in
length to connect the "OUT" jack to your equipment.
STEP 7: Plug in your DVR , then switch on theASP16. It will run a
5-second self-test to determine the strength of the battery. Refer
to page 3, item #2.
SAFETY PRECAUTIONS:
CAUTION: ASP16 has an internal battery source. When the On/Off
switch is on, the battery supplied outlets are energized, even
when the unit is not plugged in.
CAUTION: Use only indoors and in dry locations.
CAUTION: Connect the ASP16 to a 3-pronged grounded outlet. Make
sure the branch is protected by a fuse or circuit breaker, and
not servicing equipment requiring heavy electricity (e.g.
refrigerator, air conditioner, copier, etc.)
CAUTION: Never plug a ASP16 into itself; this will cause a short circuit.
NOTICE: For use in a controlled environment
Use of ASP16 in life support applications is NOT recommended.
*IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
Page 5
Electrical Specifications
Class:
Digital Recorder Protector / Battery Back-Up
Installation Point:
Audio -Video Point of Use
Agency Approvals:
UL 1778
Connection Method:
6 Foot Power Cord
Continuous Current:
12 Amps
Response Time:
5 nSec
MCOV:
130VAC
Operating Frequency:
50 - 60 Hz
AC Protection Modes:
L - G, L - N, N - G
Service Voltage:
125VAC
Diagnostics:
Ground OK, Surge Protection Active
EMI/RFI Noise Filtering:
150KHz - 100mHz up to 58dB
Max. Surge Current:
58,500Amps (Peak)
Max. Energy Dissipation: 1665 Joules (Single Pulse)
Features:
4 AC Outlets (2 Switched), 16 - In / 16 - Out
Coax, and 2 In/2Out RJ45
Battery Backup Rating:
450VA / 250W (Max.)
Battery Output Voltage:
120VAC
Battery Charge Mode:
Full Time
Battery Recharge Time: 12 Hours from total discharge (Typical)
Battery Life:
3-6 Years (Typical)
Battery Back up Response Time: 4 ms
Physical Specifications
Housing:
Painted Steel
Housing Color:
Black
Housing Size:
17.13" W x 7.31" L x 3.5" H
Weight:
14.00 lbs
ASP16
+
5%
Page 6
Advertisement
