Connecting And Switching On The Display; Connecting The Display - NEC T1000 User Manual

42” wide vga plasma
Hide thumbs Also See for T1000:
Table of Contents

Advertisement

Getting started

Connecting and switching on the display

Connecting the display

(for an overview of the connection sockets see the illustration on page 9
12
)
. Plug the mains power cord into the mains input jack on the plasma TV and
the mains plug into a plug receptacle.
Cable connection / terrestrial aerial / satellite receiver
If you would like to connect a cable, a terrestrial aerial or a satellite recei-
ver, use the ANTENNA socket for this purpose.
Video recorder / DVD player / satellite receiver
If you receive your TV channels via satellite, connect your receiver by
means of a SCART cable to the SCART 1 or SCART 2 socket.
In addition, SCART 2 has a connection socket for RGB sources,
e.g. a DVD player.
DVD player / satellite receiver
For connection of a DVD player or another video source to a YUV-output
please use the display's YUV-input and the audio input AUDIO (YUV).
If your DVD player has a HDMI output port, you can use the DVI input port
and the audio input port DVI-D/VGA (L/R) on the plasma TV using com-
mercially available cable.
If a DVD player is connected to the DVI input port of the dis-
play screen, the following must be ensured:
D Before you make a connection between the DVD player and
the display screen using the cables, you must disconnect
the mains plug of the DVD player from the plug socket.
D Once the cables are plugged in on the DVD player and on
the display screen, the mains plug of the DVD player can be
reconnected to the mains.
If you do not comply with this procedure, damage can be
caused to the DVD player or to the display screen!
VGA (RGB analogue)
Use the VGA socket to connect your PC DSUB socket to the display. For the
PC-sound, use the audio input DVI-D/VGA (L/R) at the display.
On older PC graphic cards it is possible that pin 9 is barred.
Should this be the case, please contact the service hotline.
DVI-D (RGB digital)
Use the DVI-D socket to connect your PC DVI-D socket to the display. For
the PC-sound, use the audio input DVI-D/VGA (L/R) at the display.
ENGLISH

Advertisement

Table of Contents
loading

This manual is also suitable for:

Plasmasync t1000

Table of Contents