Something Not Working - Electrolux EU 1180 U Operating Instructions Manual

Integrated built-under freezer
Table of Contents

Advertisement

Something not Working

Before contacting your local service force centre,
check the following points.
Warning! Repairs to refrigerators/freezers
1
may only be performed by qualified service
Sympton
Appliance does not work.
Appliance cools too much.
The freezer temperature is not
sufficient..
Heavy build up of frost, possibly
also on the door seal.
Unusual noises.
The compressor does not start
immediately after changing the
temperature setting.
14
Possible Cause
Appliance is not switched on.
Mains plug is not plugged in or is
loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Door seal is not air tight (possi-
bly after changing over the hin-
ges).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
This is normal, no error has
occurred.
engineers. Improper repairs can give rise
to significant hazards for the user. If your
appliance needs repairing, please contact
your specialist dealer or our Customer
Service.
Switch on the appliance.
Insert mains plug.
Check fuse, replace if neces-
sary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator
to a warmer setting temporarily.
Please look in the "Initial use"
section.
Open the door only as long as
necessary.
Turn the temperature regulator
to a colder setting temporarily.
Please look in the "Installation
location" section.
Carefully warm the leaking sec-
tions of the door seal with a hair
dryer (not hotter than approx.
50 °C). At the same time shape
the warmed door seal by hand
such that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
The compressor starts after a
period of time.
Remedy

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents