Operating Sequence - Electrolux EW 1240 W Installation And Instruction Manual

Operating sequence

Automatic washing plus drying (NON-STOP
operation)
This option is only possible for cottons and synthetics.
Maximum load:
– cotton, linen 2.5 kg
– synthetics 2.0 kg
Important:
Before washing your first load of laundry, we recom-
mend that you run a cotton cycle at 60°C, with the
machine empty, in order to remove any manufactur-
ing residue from the drum and tub.
Pour half a measure of detergent into the main wash
dispenser and start up the machine.
Place the laundry in the drum
P0004
2 Measure out the detergent
P0910
priate compartment marked
3 Measure out the additives
P0911
Open the door by press-
ing the button and
place the laundry in the
drum, one item at a time,
shaking them out as
much as possible. Close
the door.
Pull out the dispenser
drawer until it stops.
Measure out the amount
of detergent recom-
mended by the manufac-
turer in a graduated cup
and pour it into the main
wash compartment
If you wish to carry out
an extra prewash, pour
detergent into the appro-
.
If required, pour fabric
softener into the com-
partment marked
and the bleaching agent
in the compartment
marked without
exceeding the «MAX»
mark.
4 Select the drying time
Turn the selector knob clockwise to the required time
(red or blue sector, depending on the type of fabric).
5 Select the temperature
P0881
6 Select the programme and start it
P1011
Turn the programme selector clockwise to the
required wash programme and press the start/stop
button the operating light and the door lock light
come on and the machine starts to operate.
7 At the end of the programme
The machine stops automatically.
.
It is normal to have to wait for about 2 minutes before
being able to open the door to allow the safety lock to
release. The door cannot be opened until the door
lock light on the control panel goes out.
Press the start/stop button
ing pilot light goes out.
Remove the laundry.
Turn the drum by hand to make sure it is completely
empty, so as to avoid any forgotten items being dam-
aged in a subsequent wash (e.g. shrinking) or their
colour running into a load of whites.
Release any buttons which have been pressed.
Turn the water tap off and unplug the machine.
Leave the door ajar to air the machine.
Turn the selector knob to
the required temperature
setting.
P0080
again and the operat-
41