Table of Contents
Advertisement
TWEETER INSTALLATION
flush mounting the tweeter
S
1. Determine the location for the tweeter and route the wire from the
tep
crossover to the Tweeter Location.
S
2. If using the factory location, remove the factory tweeter and re-
tep
place with the Phantom tweeter. Use either the factory tweeter brakets
or affix with apoxy to assure proper fit.
S
3. If using a hole saw, first drill a pilot hole, then cut out the hole
tep
using a standard 1
S
4. Install the Tweeter housing with the included hardware. Make
tep
sure to tighten the installation screws to assure no movement from the
tweeter.
S
5. Connect the speaker wires observing the correct polarity.
tep
surface mounting the tweeter
S
1. Determine the location for the tweeter and route the wire from the
tep
crossover to the Tweeter Location.
S
2. Place the surface mount housing against the panel and mark the
tep
two holes at the rear of the housing.
S
3. Drill the smaller center hole using a 1/8" drill bit. This is the wire
tep
routing hole.
S
4. Route the speaker wire through the hole and insert the Tweeter
tep
into the surface mount hole, pay attention to the location of the wire and
look for any obstructions before finidhing.
T
: F
ip
oR a higheR sound
ambianT TweeTeRs
give you moRe up
hole saw.
3/4"
-
sTage mounT The TweeTeRs in The
(
second set of tweeters typically in the a
-
.
FRonT imaging
a-
,
pillaRs
oR use
-
) T
pillars
his will
Advertisement
Table of Contents
