Panasonic VIERA TC-P46S30 Owner's Manual page 36

This is a setting for connecting to a broadband environment.
_ Display the menu
Select "Network settings"
@seec
Network settings
[] Press to exit from
a menu screen
EXiT
Select the settings and set
[] Press to go back to
the previous screen
RETURN
@
Check that the Network settings are as shown below, and then start "Connection test".
_ Select "Connection test" and press OK _3_Complete Connection test
(It takes a while to cancel the test.) Success-->Completion screen is displayed.
_-2_ Displayed Connection test screen Error-->Follow the directions on screen to complete the setting.
If you perform the Proxy settings, check the Proxy address
and the Proxy port number.
Select Network type (Ethernet cable/Wireless (WiFi))
This setting is performed only when "Wireless (WiFi)" is selected in "Network connection" above.
[] Displayed "Current settings and status" screen (If connected with wireless LAN adapter)
You can confirm the AP connection status.
(SSlD/Wireless type/Security type/Encryption type/Connection status/Signal strength)
_ Press "Wireless network" @_When you change "Wireless network" -->Press "No"
See "Sets / Changes wireless network setting" on p. 37
and follow the directions on screen to complete the
setting.
You need to be "Connected" to use network devices.
Please set Access point settings to "Connected".
36
(example)