6 Tie the wire with the clampers attached to the display not
to .run it off the edge of the display.
Fix the wire on the back of the display not to pinch it.
Landscape
[LM55S1/P1]
[LM46P1]
Portrait
[LM55S1/P1]
[LM46P1]
7 Adjust the position of the handle(R) to turn the
adjustment screw. Loosen the nut on adjustment screws
with wrench (8mm) before adjustment.
Contact the claw of the handle with the bezel front surface.
After the adjustment tighten the nut.
Adjustment
screw
8 In the same manner, adjust the position of the handle(L)
9 Connect the cables to the display.
10 Tie the cables with bands supplied to the display not to
run the cables off the bottom edge when the panel is
closed.
The cables clamped on the wall are slacken off sufficienty
not to pull cables when the display is opened.
Holes for fixing Band
[LM55S1/P1]
fixing Band
[LM46P1]
Holes for
fixing Band
Display dismounting
Be sure to dismount the display before take off Handle(R), it's
wire and cables.
Holes for
EN-9