Pioneer VSX-819H-K Operating Instructions Manual page 32

04 Controls and displays
12 Number buttons and other component
controls
Use the number buttons to directly select a
radio frequency (page 48) or the tracks on a
CD, DVD, etc. There are other buttons that can
be accessed after the RECEIVER button is
pressed. (For example MIDNIGHT, etc.)
HDD*, DVD*, VCR*
These buttons switch between the hard
disk, DVD and VCR controls for HDD/DVD/
VCR recorders.
S.RETRIEVER
Press to restore CD quality sound to
compressed audio sources (page 36).
EQ
Press to switch on/off Acoustic Calibration
EQ setting (page 36).
CH SELECT
Press repeatedly to select a channel, then
use +/– to adjust the level (page 43).
CH SELECT +/–
Use to adjust the channel level.
SB CH
Use to select the surround back channel
mode (page 36).
PHASE
Press to switch on/off Phase Control
(page 10).
SPEAKERS
Use to change the speaker system
(page 24).
MIDNIGHT
Switches to Midnight or Loudness
listening (page 38).
SLEEP
Press to change the amount of time before
the receiver switches into standby (30 min
– 60 min – 90 min – Off). You can check
the remaining sleep time at any time by
pressing SLEEP once.
32
En
13  SOURCE
Press to turn on/off other components
connected to the receiver (see page 54 for
more on this).
14 TV CONTROL buttons
These buttons are dedicated to control the TV
assigned to the TV button. Thus if you only have
one TV to hook up to this system assign it to the
TV button. (see page 53 for more on this).

Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
15 MASTER VOLUME +/–
Use to set the listening volume.
16 MUTE
Mutes/unmutes the sound.
17 DISPLAY
Switches the display of this unit. The input
name, listening mode or sound volume can be
checked by selecting an input source.
18 SHIFT
Press to access the 'boxed' commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (* ) in this section.
This button is also used for operating ZONE 2
(page 47).