7. Appendix
Troubleshooting
This section helps you resolve problems you may encounter while setting up or using the projector.
Indicator Messages
Power Indicator
Indicator Condition
Off
Blinking light
Green
0�5 sec On,
0�5 sec Off
Steady light
Green
Orange
Red
Status Indicator
Indicator Condition
Off
Blinking light
Red
2 cycle (0�5 sec
On, 0�5 sec Off)
4 cycle (0�5 sec
On, 0�5 sec Off)
6 cycle (0�5 sec
On, 0�5 sec Off)
Green
Steady light
Green
Orange
Lamp Indicator
Indicator Condition
Off
Blinking light
Red
Steady light
Green
Over-Temperature Protection
If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the
lamp with the STATUS indicator blinking (2-cycle On and Off.)
Should this happen, do the following:
• Unplug the power cord after the cooling fans stop.
• Move the projector to a cooler location if the room where you are presenting is particularly too warm.
• Clean the ventilation holes if they are clogged with dust.
• Wait about 60 minutes until the inside of the projector becomes cool enough.
Projector Condition
The power cord is unplugged�
The projector is getting ready to turn on�
The projector is turned on�
[NORMAL] is selected for [STANDBY MODE]
[POWER-SAVING] is selected for [STANDBY
MODE]
Projector Condition
Normal or Standby ([POWER-SAVING] for
[STANDBY MODE])
Temperature error
Fan error
Lamp error
Re-firing the lamp (The projector is cooling
down�)
Standby ([NORMAL] for [STANDBY MODE])
Cabinet button is locked
Projector Condition
Normal
Lamp has reached its end of life� Lamp
replacement message will be displayed�
[ECO MODE] is set to [ON]
67
Note
–
Wait for a moment�
–
–
–
Note
–
The projector is overheated� Move the projector to
a cooler location�
Fans will not work correctly�
Lamp fails to light� Wait a full minute and then
turn on again�
The projector is re-firing.
Wait for a moment�
–
You have pressed cabinet button when Cabinet
Button is locked�
Note
–
Replace the lamp�
–