Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Hurco Power Smoker 2
- Page 1 R E F E R E N C E M A N U A L Reference Manual and User’s Guide 1-800-888-1436 • gethurco.com • info@gethurco.com www.GETHURCO.com...
-
Page 3: Welcome
Power Smoker 2. Your Power Smoker 2 will give you many years of service if you take care of it as you would any expensive piece of equipment. The Power Smoker 2 is rugged and built to last. It will withstand the demands of your jobsite;... -
Page 4: Table Of Contents
General Safety Information ..........3 Power Smoker 2 Setup for Sewer Systems ......4 Preparing for Smoke Testing . -
Page 5: General Safety Information
Once the repair has been made, recheck the system using the Power Smoker 2. Carbon Monoxide does travel with the smoke being generated by the Power Smoker 2. Under normal conditions, the amount of Carbon Monoxide emitted with the smoke is minimal and should not be a problem. However, as with any gas, if you let it accumulate it can build to dangerous levels. -
Page 6: Power Smoker 2 Setup For Sewer Systems
Operating Instructions Power Smoker 2 Setup for Plumbing Systems • Setting up your Power Smoker 2 for smoke testing a plumbing Video or digital camera gear • system involves some planning. The most important part of Laser light pen and marker tags. -
Page 7: Procedures For Smoke Testing
Power Smoker 2 fan housing. For a typical house, On new plumbing, inspect for leaks prior to the this would be the approximately the thickness of a installation of floors, walls and ceilings. -
Page 8: Power Smoker 2 Parts Breakdown
This parts breakdown is to help you identify any parts that may need to be replaced or repaired. remove or install the cast aluminum blower. Call Hurco if repairs are required on the Power Smoker 2 blower. DO NOT You should never remove or install the cast aluminum blower. Call Hurco if repairs are required ATTEMPT TO MAKE THIS REPAIR ON YOUR OWN. -
Page 9: Troubleshooting
Question: Why is my Power Smoker 2 spitting out too much LiquiSmoke? Answer: The valve on the Power Smoker 2 that controls the flow of the LiquiSmoke is open too far. This will allow too much fluid to enter the Smoke Generator causing it to cool and not properly atomize the LiquiSmoke. It is advisable to practice with the Power Smoker 2 to determine the exact position of the flow control valve to produce the maximum smoke with little wasted LiquiSmoke prior to use on a job. - Page 10 1-800-888-1436 • gethurco.com • info@gethurco.com Rev: 03-19-12-1 Part PS2OM...
Need help?
Do you have a question about the Power Smoker 2 and is the answer not in the manual?
Questions and answers