Maintenance - Sears Craftsman 919.679370 Owner's Manual

Connecting Electrical Loads
• Let engine run and warm up for about five minutes
after starting.
• Plug in the desired 120 or 240 volts tools.
• DO NOT connect 240 volt equipment to the 120 volt
duplex receptacles.
• DO NOT connect 3-phase loads to the panel
receptacles.
IMPORTANT: You should always add up the rated
watts of all lights, tools and appliances you are pow-
ering at one time. This total should not exceed the
rated capacity of your generator or circuit breaker rat-
ing of the receptacle supplying power.
CUSTOMER RESPONSIBILITIES TABLE
MAINTNENANCE TASK
Check oil level
Change oil
Clean Air Filter Assembly
Check Spark Plug
Prepare Unit for Storage
Note 1: Change oil after first five (5) operating hours and every 50 operating hours thereafter, more often if operated in
extreme dusty or dirty conditions.
Note 2: Check oil after 5 hours of operation (See page 14 - ENGINE MAINTENANCE - Changing Engine Oil.)
Stopping The Engine
• Disconnect all electrical loads.
• Switch the start/off switch to the off position.

MAINTENANCE

Before each Every 25
use Hours of Every
Season
X See Note 2
Prepare unit for storage if it is to remain idle for more than 30 days.
13 — ENG
IMPORTANT: Never store engine with fuel in tank,
indoors, or in enclosed, poorly ventilated areas or
where fuel fumes may reach an open flame.
Every 50
Hours of Every
Season
See Note 1
X
X
Every 100
Hours of Every
Season
X