Savin 3045 Operating Instructions Manual page 20

Getting Started
A
Open the bypass tray.
1
B
Adjust the paper guides to the pa-
per size.
Open out the extender to support
paper sizes larger than A4 L, 8
×11 L.
Important
❒ If the paper guides are not flush
against the paper, skewing and
misfeeds might occur.
1.
Extender
2.
Paper guides
14
C
Gently insert paper face up into
the bypass tray until the beeper
sounds.
Note
❒ The beeper will not sound if it is
turned off. Gently insert paper
until it stops.
❒ Do not stack paper over the lim-
it mark, otherwise a skewed im-
AJL006S
age or misfeeds might occur.
❒ Fan the paper to get air between
the sheets to avoid a multi-sheet
feed.
D
1
/
Select the paper size.
2
Note
❒ The following procedures are
not required if you select [Driver
/ Command] from [Bypass Tray
Setting Priority] in [System] of
[Printer Features] (see p.128 "Sys-
tem"). In that case, set the paper
size using the printer driver.
❒ If you select [Machine Settings]
from [Bypass Tray Setting Priority]
in [System] of [Printer Features]
(see p.128 "System"), the set-
tings made using the control
panel have priority over the
printer driver settings.
❒ If the printer driver is not used,
AJL007S
select [Machine Settings] from
[Bypass Tray Setting Priority] in
[System] of [Printer Features] (see
p.128 "System"). Set paper size
using the control panel.