Table of Contents
Advertisement
3. Mounting the main body a
Ensure that two or more people undertake the
following step of the assembly process.
Lift the main body a and carefully place it onto the stand.
Position the main body towards the front of the stand, so that
the metal fi tting holes are visible when viewed from above.
Gently slide the main body backwards until the base engages
with the fi xings inside the side panels and locks into place.
When lifting the main body onto the stand, be
careful not to catch/trap hands and fi ngers.
Temporarily fi x the main body to the stand using two screws
i, again leaving a 1-2 mm tightening allowance.
Secure the main body to the stand from below, using the four
screws (with the fl at washer and spring washer) h.
First, loosely attach all four screws, adjusting the position of
the main body on the stand. When all four screws are attached
and the main body is correctly positioned on top of the stand,
securely tighten all screws.
Then securely tighten all the screws i and j.
4. Connecting the pedal and power cables
Connect the pedal cable to the PEDAL terminal located on the
underside of the main body, ensuring the notched plug faces
the rear of the instrument.
Connect the AC power cable f to the AC IN terminal.
Use the binders to fi x the cables in place.
Pedal plug
AC adaptor
7. Attaching the headphone hook (optional)
If desired, attach the headphone hook to the underside of the
main body using the two tapping screws provided.
h
h
h
h
Tighten all screws securely to ensure that the
Tighten all screws securely to ensure that the
main body is fi rmly attached to the stand.
main body is fi rmly attached to the stand.
Failing to do so may result in serious injury.
Failing to do so may result in serious injury.
5. Attaching the Cover strips
Attach the cover strips g to the
rear of the instrument, where
the left and right side panels
meet the main body.
Binder
6. Mounting the Music Rack
Insert the music rack c into the top board of the main body.
8. Adjusting the pedal support bolt
Turn the pedal support bolt anti-clockwise until it makes
contact with the fl oor and supports the pedals fi rmly.
Pedal support bolt
i
i
i
i
h
h
h
h
g
g
c
41
Advertisement
Table of Contents
