Advertisement
PROBLEM
SNAGS, HOLES
TEARS, NPS OR
EXCESSIVE WEAR
(continued)
HEAVILY SOILED
AREAS
such as collars
and cuffs
WASHER WON'T
OPERATE
WATER
TEMPERATURE
IS INCORRECT
WATER WON'T
DRAIN
24
(continued)
POSSIBLE CAUSE
Chemicals
such as hair bleach, dye, permanent wave solutions, battery acids and
toilet bowl cleaners may cause fabric holes. Rinse dl towels and other articles
that came in contact with these chemicals before putting them in wash. Do not
contaminate clothing articles with these chemicals.
Small, unnoticed tears may enlarge during washing process. Check garments before
washing and mend all rips and tears.
As Permanent Press garments age, they may show fraying at collars and cuffs. This
normal due to weakening of fibers by the Permanent Press process. It is not caused
is
by washer. You can slow this process by washing small Permanent Press loads with
a Large Water Level. Do not wash heavy items such as towels with Permanent Press.
Remove collar stays, when possible.
Roughness or burrs on agitator may cause rips or tears. Check agitator and file rough
spots if necessary.
May be caused by the use of Regulm Cycles for delicate articles. Use Permanent Press
Cycle. Refer to Garment Manufacturer's Care Labels,
Garments weakened by age, sun or atmosphere. This is inevitable and is not caused
by washer.
move freelv. Select correct water level.
Pretreat with liquid detergent. Use Extra Cleaning cycle, see Tips to Help You
Select Settings section.
Make
sure cord is plugged into outlet.
Make sure both hot and cold faucets are turned on.
Make sure lid is closed. Washer will fill but will not spin or agitate with lid open.
Check house fuses or circuit breakers. If another appliance is sharing the electrical
outlet, remove it. Washer should have separate outlet.
Make sure temperature selector controls are correctiy set.
Make
sure hot and cold faucets are turned on and regulated correctly.
sure hoses are connected to correct faucets...
Make
hot to hot, cold to cold.
Water valve screens may be stopped up. Remove inlet hoses
from water valve. Clean the screens and reinstall hoses.
Check house water heater to make sure it is delivering water at
Make sure drain hose is not kinked.
Top of drain outlet should be less than 8 ft. (2.4 m) above floor.
Make sure hose connections are tight at faucets.
Make sure end of drain hose is correctly inserted in and secured to drain facility.
o + 5 {
Advertisement
