Advertisement
Quick Links
8. VAXCARE Service & Help:
AUSTRALIA 1300 361 505
NEW ZEALAND 0800 800 900
If you have any queries or concerns about
using your Vax, call VAXCARE. Please make
a note of the part number or model number
of the appliance before calling.
(Aust only: Mon-Fri. 8:30am - 5:30pm. EST)
Calls are charged at the local rate.
An answerphone is available outside of
these hours. We will return your call the next
working day.
There are over 300 approved Vax Service Agents
in Australia and New Zealand. For the nearest
Service Agent, please refer to your Vax warranty
or call VAXCARE or visit www.vax.com.au
9. Technical Specification
Voltage
220-240V~50Hz
Wattage:
1400W Model VCC-05
1500W Model VCC-07
Capacity:
6 litres max Model VCC-05
8 litres max Model VCC-07
Filters:
Pre-motor filter VCC-05 only
HEPA Model VCC-07 only
Cord length: 12 metres
Weight:
7.2kg Model VCC-05
8.5kg Model VCC-07
Subject to technical change without notice.
Commercial User Guide.indd 1
10. Troubleshooting
WARNING: To reduce the risk of injury,
unplug the vacuum cleaner before servicing.
PROBLEM: Vacuum cleaner won't run
Cause: Not properly plugged into electrical outlet.
Solution: Plug unit in firmly.
Cause: Vacuum cleaner not turned on.
Solution: Press on/off button.
Cause: No electricity in the electrical outlet.
Solution: Check fuse or breaker.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
Cause: Motor thermostat has tripped.
Solution: Switch off and unplug the vacuum
cleaner. Leave for one (1) hour. See page 2.
PROBLEM: Cleaner won't pick up/
loss of suction
Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and
replacement.
Cause: Dust bag full or blocked.
Solution: Replace dust bag. Empty/clean/
replace cloth bag
Cause: Clogged filter.
Solution: Remove/replace with new filter VCC-05.
Remove wash/replace HEPA filter VCC-07.
Cause: Blockage in hose.
Solution: Disconnect hose, remove the
obstruction then re-fit.
PROBLEM: Accessories won't pick up
Cause: Accessories are not attached correctly.
Solution: Refer to page 5 for fitting information.
PROBLEM: Dust escaping from the
vacuum cleaner
Cause: Dust bag full.
Solution: Dispose of paper dust bag, replace
with a new one or empty/clean/replace cloth bag.
Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and
replacement.
Cause: Hose is not installed correctly.
Solution: Review hose installation.
Cause: Filter not installed completely.
Solution: Review filter removal and
replacement.
www.vax.com.au
Workman
VCC-O5
VCC-07
12 Month VAXCARE Commercial Warranty
Instruction Manual
Vaxcare:
AUST: 1300 361 505
NZ: 0800 800 900
Please read carefully before using the cleaner.
Always fully extend the mains cable before use.
5/10/07 11:12:18 AM
Advertisement
Related Manuals for Vax VCC-O5
Summary of Contents for Vax VCC-O5
- Page 1 Solution: Check fuse or breaker. working day. Cause: Blown fuse/tripped breaker. VCC-O5 There are over 300 approved Vax Service Agents Solution: Reset circuit breaker or replace fuse. in Australia and New Zealand. For the nearest Cause: Motor thermostat has tripped.
-
Page 2: Clearing Blockages
IMPORTANT: If the inlet or hose is blocked, water. Return the vacuum cleaner to a Vax (Fig.7/1). switch off the vacuum cleaner and remove the Authorised Service Agent for examination, blockage(s) before re-starting. -
Page 3: Parts Overview
2. Unclip the retainer clip on the top of the vacuum cleaner and lift up to gain access to the dirt container department. (Fig.6/3) Fig.6/5 NOTE: Vax recommends replacing the pre- motor filter when it becomes discoloured. 1 Hose inlet 7 Exhaust grill 13 Extension tubes Fig.6... - Page 4 3. How to Assemble 4. How to Operate 5. Accessories Fig.4/4 Fully unwind the power cord. The accessories can be attached directly to the handle by removing the extension tube On/Off Button and pushing in the desired accessory. Insert the power plug into the electrical outlet. The accessories can also be attached to Ensure the vacuum cleaner is switched off.