Advertisement
Installing a new battery
Before installing a new battery, Press and
hold any button for at least two seconds
1. Insert a new battery in case back location as
shown in Figure 3. Positive (+) end must
face up. Use Panasonic CR2032, Maxell
CR2032, Duracell DL 20325, or Varta CR2032
lithium battery only.
Improper installation will result in
damage to the battery.
2. Close the case by snapping case front and
back together.
3. Press any button and verify that the LED
flashes.
Signals sent by wireless transmitters may be blocked or reflected by metal objects before they reach the alarm
receiver. Even if the signal path has been recently checked during a weekly test, blockage can occur if a metal object
somehow blocks the signal path.
Wireless button type transmitters that have visual and audible indications of status must be used to confirm that
the desired action (such as arming) has occurred after pressing a function button on any of these transmitters. Be
sure to listen for appropriate audible and visual indications that such action has occurred. Otherwise, you could
inadvertently leave yourself or your premises unprotected.
External factors such as humidity, high or low temperatures, or constant activation of a programmed button may
reduce battery life in a given installation. If the button unit is used infrequently, activate it regularly (once per
week) to confirm operation. A button type transmitter will report a low battery condition to the alarm control when
a low battery status is detected.
FOR WARRANTY INFORMATION AND FOR DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM,
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED.
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES and RSS210 OF INDUSTRY CANADA. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,
AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
‡K5761V2XŠ
K5761V2 7/06 Rev. A
LIMITATIONS STATEMENT
FCC AND INDUSTRY CANADA STATEMENT
165 Eileen Way, Syosset, New York 11791
Copyright © 2006 Honeywell International Inc.
www.honeywell.com/security
INSERT THIS
END FIRST
Figure 3 - Installing the Battery
INSTALL UNDER THIS TAB
AND ATOP THIS TAB
NOTE
POSITIVE (+) SIDE
MUST FACE UP
5805-008-V2
Advertisement
