YATOUR YT-M05B User Manual page 4

2. Unmount the radio from the dash in order to get access to the back side
of the radio, and find CD Changer port at the back of the radio.
3. Attach the wire harness connector to the back of the stereo to the CD
changer port. Be sure to make a firm connection but do not force it.
4. Connect the iPod/iPhone with adapter through the iPod cable. Switch
on the electric power and run the radio(ON/OFF for twice), Press the
CD (or Disc/ Mode/ CDC/ SOURCE/ AUX) button on radio repeatedly
until "CD x-x" appears on the radio display (x is the track number of
"Now Playing" song on iPod). This display confirms that iPod mode has
been completely synchronized and activated. Synchronization timing
varies according to the number of Playlists on your iPod.
5. After successful test, assemble the Head Unit , and put wire harness
and module unit box in proper place. Then installation is completed.
Important Note :
1. If there is a BLACK ground wire on the harness, please attach it to any
metal part of the car stereo body; If there is a YELLOW power wire on
the harness, please attach it to the power of the car, which connect to
battery; If there is a RED ACC wire on the harness, please attach it to
the ACC signal of the car. Without attaching those cables to the right
position, this iPod Car Adapter will not work!
2. As to some vehicles with existing CD Changer, Parallel Harness or
MP3/CDC Switch Cable will be provided. This allows Digital Music
Changer to hook up with existing CD Changer. Simply connect the
existing CD Changer to the male connector of Digital Music Changer.
(As shown in pre-text diagram)
3. Regarding Fiat, Renault models, two black wires with metal ends
(male+female) come along with CDC connector. If noise problem
exists when using iPod Car Adapter, please hook up the two
grounding wires with each other.
4. As for Audi factory radio of mini ISO 8 pin, its CDC connector is 20-pin
block connector, in order to install iPod Car Adapter, it requires to cut
the 8-pin part or connect with our special Audi 20-pin adapter cable.
5. As for Clarion protocol radios, such as some BUICK radio and SUZUKI
radio, it requires to totally unplug the wire harness before installation,
in order to power off the electric supply. If not, it would probably cause
—[3]—