Download Print this page

On/Off Switch; Battery Removal - Conair GMT255CSC Instruction Booklet

Advertisement

blendIng the JawlIne
1. The three jawline attachments will help you
to achieve a neat, finished trim under your
chin. To use one of the attachments, press it
down over the trimmer blades until it clicks
into position.
2.Hold the trimmer in an upright position and
begin trimming under your jawline, using
short, even strokes.
3.After your beard is blended, turn off the
trimmer and remove the attachment by
gently pulling up on tab.
to trIm your muStache
1. For best results, start with a clean, slightly
damp mustache.
2.Comb through your mustache in the direction
it grows.
3.Place the 5-position
comb over the facial hair
blade and snap it into
position. It is a good idea
to start with the longest
trim setting adjustment. (You can always go
back and cut your mustache more closely
with a shorter setting.)
alwayS trIm your muStache
from the top down
4. After your mustache
has been trimmed to the
desired length, remove
the 5-position comb and,
using the blades only, define the outline of
the bottom of your mustache.
5. Use the precision goatee trimmer blade for
fine detailing and hair art.

on/off SwItch

To operate, simply slide switch toward blade,
to stop push slide away from blade.
care of your trImmer
replacement (removal) of blade Set
To remove blade set
from
your
trimmer,
make sure the trimmer
is in the OFF position.
Remove the blade set by
placing thumb against
the smaller cutter and
pushing forward, releasing
the cutter assembly from the trimmer housing.
Replace with new cutting system and reverse
the removal procedure, only this time place your
thumb on the large cutter and snap into place.
Make sure the taper control is set to the longest
#1 position.

battery removal

CONTAINS NICKEL CADMIUM
BATTERY. MUST BE COLLECTED,
RECYCLED OR DISPOSED OF
PROPERLY. DO NOT DISPOSE OF
IN THE MUNICIPAL WASTE.
1. Using a small Phillips head screwdriver,
remove the 3 screws at the back of the
trimmer.
2. Remove the bottom housing and push the
batteries out and disconnect the leadwire
connected with +/– pole. Bring the batteries
to the nearest collection center for proper
disposal. DO NOT throw the battery into the
normal municipal waste system.

Advertisement

loading