Pulling Up The Bobbin Thread - Brother 885-V15 Operation Manual

Pulling up the bobbin thread

When making gathers or before free-motion quilting, first pull up the bobbin thread as described below.
a Insert the bobbin into the bobbin case.
a
• Refer to steps through
bobbin" on page 18.
b Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
• Leave the bobbin cover removed.
Turn on the sewing machine.
c
d Lightly hold the end of the upper thread.
a Upper thread
e With the needle raised, press
position button) twice.
a Needle position button
d
of "Installing the
a
(needle
f Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
b
a Upper thread
b Bobbin thread
g Pull out about 10 cm (4 inches) of the bobbin
thread under the presser foot toward the rear
of the machine.
a
b
a Upper thread
b Bobbin thread
h Turn off the sewing machine.
i Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover (A), and then press down on the
right side (B).
A A
a
2
B
51