Table of Contents
Advertisement
Video Switch
Contents
Unpacking the Video Switch
What's in the box
1 Video Switch Unit
4 Rubber Feet
1 HD Camera cable (1 m) for 6000MXP Codec
1 HD Camera cable (1 m) for 3000MXP Codec
1 Power supply kit incl. cables for Video Switch
1 Power supply kit incl. cables for existing camera
1 Rack ear set (left and right)
1 Control cable (6.5 m) for Video Switch to Precision HD camera
1 HDMI cable (6.5 m) for Video Switch to precision HD camera
1 TRC4 TANDBERG Remote Control
Please report any discrepancies immediately.
1
Unpack the unit.
D14794.02 Video Switch User Guide, October 2012
© 2011-2012 Cisco Systems, Inc. All rights reserved.
Introduction
The Video Switch
The Video Switch
2
Mount the rack ears
and/or rubber feet
and mount it in the
rack, if applicable.
Safety instructions and approvals
The Video Switch
The Video Switch (TVS) is a rack-mountable hardware option for the Cisco TelePresence MXP
Series codecs (6000 MXP and 3000 MXP). The Video Switch delivers the ability to daisy chain
multiple HD cameras and provides support for third party HD cameras.
Codec software
The Codec must be equipped with software version F6.1 or higher to support the use of the
Video Switch.
About cameras
You may combine Cisco TelePresence PrecisionHD 720p cameras with analog sources
equipped with component video outputs. Just add them to the chain of cameras in the diagram
shown overleaf, but make sure the added sources appear after the PrecisionHD cameras in the
chain (i.e. after camera 4 in the diagram overleaf).
Consequently, up to four Cisco TelePresence PrecisionHD 720p cameras may be combined with
up to two analog component video sources.
6
User guide
Contact us
Put the Video Switch
power supply here when
rack mounting.
Rubber feet
(rubber pads)
www.cisco.com
Advertisement
Table of Contents
