Summary of Contents for Kramer VS-16N
- Page 1 KRAMER ELECTRONICS, Ltd. USER MANUAL 6X1 Switchers / Scanners Models: VS-16N VS-16A IMPORTANT: Before proceeding, please read paragraph entitled "Unpacking and Contents" KRAMER ELECTRONICS LTD. P/N: 2900-002006...
-
Page 2: Table Of Contents
Factors Affecting Quality of Results SPECIFICATIONS HOW DO I GET STARTED? UNPACKING AND CONTENTS Optional Accessories VS SERIES SWITCHERS/SCANNERS Getting to Know Your VS-16N Switcher/Scanner Getting to Know Your VS-16A Switcher/Scanner INSTALLATION Rack Mounting CONNECTING TO VIDEO and AUDIO DEVICES USING the VIDEO/AUDIO SWITCHERS/SCANNERS Controlling the Switcher 8.1.1... -
Page 3: Introduction
In addition to the Kramer line of high quality switchers, such as the one you have just purchased, Kramer also offers a full line of high quality distribution amplifiers, processors, interfaces, controllers and computer-related products. This manual includes configuration, operation and option information for the following products from the Kramer VS line of switchers/scanner. -
Page 4: Specifications
If the section doesn’t apply to you, you don’t have to spend your time reading it. UNPACKING AND CONTENTS The items contained in your Kramer VS switcher/scanner package are listed below. Please save the original box and packaging materials for possible future shipment. Switcher/Scanner... -
Page 5: Optional Accessories
4.1 Optional Accessories The following accessories, which are available from Kramer, can enhance implementation of your switcher. Rack Adapter - Used to adapt smaller machines to a standard 1U rack. One or more machines may be installed on each adapter. -
Page 6: Getting To Know Your Vs-16N Switcher/Scanner
VCRs. The VS-16N can be programmed to scan automatically, skipping unused inputs if desired. It can be controlled by front panel buttons, RS-485, or by simply shorting the relevant pin to ground on the back panel screw terminal connector. -
Page 7: Getting To Know Your Vs-16A Switcher/Scanner
5.2 Getting to Know Your VS-16A Switcher/Scanner The Kramer VS-16A is a high performance two-channel 6x1 scanning switcher compatible with a wide variety of signals including audio, video, and component video using dual RCA connectors. Inputs can be selected manually in addition to the typical scanning mode. -
Page 8: Installation
CONNECTING to VIDEO AND AUDIO DEVICES Connect from one to six sources (or dual signal sources) to the inputs on the rear panel of the VS-16N (VS-16A) using recommended cables, taking care that all connections are correct. Connect a signal acceptor to the output sockets on the rear panel of the VS-16N or VS-16A. If your are setting up a multi-switch system, (an 18x1 scanner system for example) all output connectors should be connected in parallel using "T"... -
Page 9: Self Address
When you reached the required input, press the ENTER key, then this input will be routed to the output. The switching in the VS-16N machine takes place during the Vertical Interval derived from source number 1. The switching in the VS-16A takes place immediately when the button is touched or when an internal... -
Page 10: Taking Care Of Your Switcher
If not, turn the acceptor/source power switch off and on again to reset the machine. 2. If the following recommended actions still do not result in satisfactory operation, please consult your KRAMER Dealer. 10.1 Video and other High Frequency Signals Problem Remedy No signal at the output 1. -
Page 11: Audio Signal
1) Any product which is not distributed by Kramer or which is not purchased from an authorized Kramer dealer. If you are uncertain as to whether a dealer is authorized, please contact Kramer at one of the agents listed in the web site www.kramerelectronics.com. - Page 12 EXCLUSION OF DAMAGES Kramer’s liability for any defective products is limited to the repair or replacement of the product at our option. Kramer shall not be liable for: Damage to other property caused by defects in this product, damages based upon inconvenience, loss of use of the product, loss of time, commercial loss;...
- Page 13 The list of Kramer distributors appears on our web site: www.kramerelectronics.com From the web site it is also possible to e-mail factory headquarters. We welcome your questions, comments and feedback. KRAMER ELECTRONICS, LTD. 3 Am VeOlamo Street. Jerusalem 95463, Israel Tel: (972-2)-654-4000. Fax: (972-2)-653-5369...
Need help?
Do you have a question about the VS-16N and is the answer not in the manual?
Questions and answers