Advertisement
Initial Power Selection
IMPORTANT
Battery charger introduction
The battery chargers supplied by Helitowcart are automatic: when the batteries are fully charged the
charger switches to a low intermittent charging mode. This low charging mode ensures that batteries are
kept in optimal charging condition since they naturally loose power slowly even when not used. These
battery chargers can be left unattended during the charging process.
The following images are for a typical battery charger. Your unit may have a slightly different configuration.
Consult specific instruction for your particular battery charger in the annex section at the end of this
manual.
Output Fuse
Battery charging
status indicator
Set voltage selector to appropriate setting PRIOR TO initial use.
Select 115 or 230 Volts according to local electrical services.
Failure to do so could lead to major battery charger damage.
115 VAC, Connector
24 or 48 VDC
Connector
On/off Indicator
Page 7 / 14
On/off Switch
(On some
chargers only)
Important:
115 AC / 230 AC
Selector
3.0 UNPACKING
Input Fuse
(On some
chargers only)
115 VAC,
Connector
Advertisement
