Advertisement
Adjusting the Time Manually
You can perform the following procedures to adjust the time and date when the watch is unable to
receive a time calibration signal for some reason.
I To enter the adjustment mode
During normal timekeeping, hold down the A button for about fi ve seconds until the second hand moves
to "READY" and then to either AM or PM, depending on the current time setting.
• Holding the B button will cause the second hand to start to move at
high speed. To stop high-speed hand movement, press the B button
again. High speed hand movement also will stop automatically if the
hour hand completes one revolution (12 hours).
• The watch will exit the adjustment mode automatically if you do not perform any operation for
about two or three minutes.
Operation Guide 4323 (GMS)
Home Position Adjustment
If the time setting of your watch is not correct even though time calibration signal reception is being
performed normally, use the procedure in this section to check the home positions of the hands
and make adjustments as required.
Note that you do not need to perform the following operation if your watch is showing the correct
time.
I To enter the home position adjustment mode
• During normal timekeeping, hold down the B button and then the A button, keeping both buttons
depressed for about fi ve seconds until the second hand stops in the vicinity of 12 o'clock.
• Holding the B button during second, hour, and minute hand
adjustment will cause the second hand to start to move at high speed.
High-speed movement will continue even if you release the B button.
To stop high-speed hand movement, press the B button again.
High-speed second hand movement will stop automatically after the
hand completes a 60-second revolution. High-speed hour and minute
hand movement will stop automatically after the hands complete a
12-hour cycle.
• The watch will exit the home position adjustment mode automatically if you do not perform any
operation for about two or three minutes.
3
Advertisement
