Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Konig VID-TRANS10SKN
- Page 1 VID-TRANS10SKN 2.4GHZ WIRELESS AUDIO/VIDEO SYSTEM OWNER’S MANUAL...
-
Page 2: Important Safety Precautions
that to which the receiver is connected. ■ Important-Safety Precautions Consult the dealer or an experienced radio/TV technician for help. This device of which operation is subject to the following two conditions (1) This device may not cause harmful interference, and A. - Page 3 ■ The Using Attention B. Introduction to 2.4GHz Wireless AV Link This sender system is a wireless audio/video sender that uses advanced 1. The outlet of the power supply must have the same voltage as the local wireless communication technology to deliver consistently sharp audio and area.
- Page 4 REAR VIEW FOR TRANSMITTER C. Panel Controls and Features of Duplex Function Type The following illustrations show the names of each component, button and switch connectors on the transmitter and receiver. (e.g.2283T/R) FRONT VIEW FOR TRANSMITTER AND RECEIVER UHF antenna sends and Directional 2.4GHz receives remote control antenna sends and...
-
Page 5: Video Sources
D. Setting Up 2.4GHz wireless AV Link Make sure the ON/OFF switch is in the position before connection. ■ How To Transmit Audio/Video from Your VCR To enjoy wireless video and audio, just connect the transmitter (2283T and all 1. Connect one set of audio/video (A/V) cables (RCA or SCART cable) to the the others) to whatever audio/video source you want to enjoy from another A/V jack of the transmitter (2283T) and to the A/V output jacks (RCA or location, and connect the receiver (2283R and all the others) to the TV, monitor... -
Page 6: Satellite Receiver
■ How To Transmit Audio/Video from Your Satellite Receiver ■ How To Receive Wireless Audio/Video Signals on Your TV You can transmit audio/video either directly from your satellite receiver, or by There are two ways to receiver wireless audio/video signals on your remote connecting them to your VCR. - Page 7 ■ Connecting Receiver to Remote TV through VCR E. Orienting Units for Optimum Performance This sender system should be placed on a flat, stable surface to prevent This setup enables you to record transmitted audio and video on your remote VCR damage to it from falling.
- Page 8 ANTENNA F. Using the Remote Control Feature ANTENNA PITTED PITTED SIDE SIDE This sender system not only allows you to send crisp audio/video from one area to another, it also gives you the ability to control the source using your ANTENNA PITTED existing remote control device.
-
Page 9: Troubleshooting, Care And Maintenance
■ How to Use the IR Extender Accessory G. Troubleshooting, Care and maintenance The IR extender connects to the transmitter through its own special connector Please read this owner's manual carefully and follow the steps described in it. plug. The extender emits an IR signal can control your A/V equipment with If you still have difficulties, consult the following table. -
Page 10: Specifications
GENERAL INFORMATION: H. Specifications MANUFACTURER/IMPORTER Transmitter: Operating Frequency Band 2.400GHz~2.4835GHz Nedis B.V. Output Level 90 dBµV/m at 3 meters De Tweeling 28 Modulation (video and audio) 5215MC ‘s-Hertogenbosch Channel PLL frequency synthesizer The Netherlands Video Input Level 1V p-p ＠ 75 ohm Tel.: 0031 73 5991055 Audio Input Level 1V p-p ＠... -
Page 11: Declaration Of Conformity
(manufacturer’s name) De Tweeling 28, 5215MC, ‘s-Hertogenbosch, The Netherlands (manufacturer’s address) Declare under our responsibility that the radio product: KONIG VID-TRANS10SKN (name) (type or model) 2.4Ghz Transmission / Reception System (product description) to which this declaration relates is in confirmity with the following standards: Radio: EN 300 220-3 (2000-09);...
Need help?
Do you have a question about the VID-TRANS10SKN and is the answer not in the manual?
Questions and answers