Advertisement
[11
l
/
2. Put the drawer slides back on
the frame. 'I'hesloped ends must
beat the front.
3. Reach in, push the front of the
glass cover up and, at the same
time, pull it forward until it clears
the frame at the back.
4. Tilt and removethe glass cover.
3. Slide the center and right drawer
slides towardthe middle and slide
the l/3-width drawer all the way
into them.
5. Removethe 3 drawer slides.
6. Removethe drawer frame as
foJlows:
~ Lift the front of the frame to free
it from the supports at each side.
~ Lift the rear of the frame to free
its hooks from the tracks on the
back wall of the refrigerator.
QTilt the frame and take it out.
'h replace:
1. Fit the hooks on the drawer
frame into the second-from-the-
bottorn slots on the tracks at the
rear of the refrigerator and lower
the front of the frame until it locks
into position and rests on the front
supports at each side.
/'-'% —.
1 ~
..-.-"
4. Slide the l/3-width drawer all the
wayto the right.
5. Mount the 2/3-width drawer
onto the center and left slides.
, ~. Replace the glass cover, pushing
lts rear edge firmly into the rear
frame channel and gently lowering
the front into place.
To removethe drawers,lift front up
-------, ------
slightlyand puHthe drawerstraight
out.
[
To removethe cover,support it
with one hand, tilt it and take it out.
. .. .-
J
S
A
1
~.
-
If the cover suPPortat front center,
(on models so"~quipped) b ecomes
separated from the drawer cover,
reinstallthe supportbeforereturning
the cover to the cabinet.
,-
To
'ffeinst.d
-
Wwer
support,
turn the cover and support upside
down and guide the pins on the
support into the hooks on the cover
as shown. Then push firmly until
the pins lock into place.
pqy)
9
-. ...
Advertisement
