Download Print this page

Maintenance - HoMedics VM-100 Instruction Manual And Warranty

Back charger massage mat

Advertisement

Available languages

Available languages

• Never leave the appliance unattended, especially if children are present.
• Never cover the appliance when it is in operation.
• Do not use this product for more than 15 minutes at a time.
• Extensive use could lead to the product's excessive heating and shorter
life. Should this occur, discontinue use and allow the unit to cool before
operating.
• Never use this product directly on swollen or inflamed areas or skin
eruptions.
• Do not use this product before bed. The massage has a stimulating effect
and can delay sleep.
• This product should never be used by any individual suffering from any
Please Note:
physical ailment that would limit the user's capacity to operate the controls.
For your safety, this
• This unit should not be used by children without adult supervision.
product is equipped
Instructions for Use
with a pressure
activated switch
Plug adapter into a 120 volt AC outlet and plug the receptacle end into the input
to control the heat
jack, located along the side of the mat. For optimum comfort, we recommend
that you use your mat massager on soft surfaces only.
function. Heat will
not operate unless

Maintenance

pressure is applied
to this switch,
To Fold
located between
This massage mat incorporates a unique strapping system that allows you to
the lower and legs
fold the unit for storage and transportation. This massage mat incorporates a
massage zones of
folding method similar to an accordion (see Diagram A-D). Fold the top portion
the unit (see page
inward so the heat seal pattern is always facing up. Repeat this method. You
7). Once pressure
can also roll up the mat for storage. Then pull the elastic strap, sewn into the
is removed, heat
mat, around the unit.
will turn off. After
To Store
applying pressure,
Place massager in its box or a safe, dry, cool place. Avoid contact with sharp
please allow 5-10
edges or pointed objects which might cut or puncture the fabric surface. To
minutes for heat
avoid breakage, do not wrap the power cord around the unit. Do not hang the
to reach maximum
unit by the controller cord.
temperature.
To Clean
Unplug the unit and allow it to cool before cleaning. Clean only with a soft,
slightly damp sponge. Never allow water or any other liquid to come into contact
with the unit.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, gasoline, kerosene, glass/furniture
polish or paint thinner to clean.
• Do not attempt to repair the massager. There are no user serviceable parts.
For service, send the unit to the HoMedics address listed in the warranty
section.
4
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
A
may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such modifications
could void the user authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
B
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off an
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
C
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
D
5

Advertisement

loading