Table of Contents
Advertisement
INTRODUCTION
The WeatherTech
pulse maintenance. The SmartCharge 200 is designed to offer maximum life for the bat-
tery. SmartCharge 200 is a member of a family of professional chargers from MacNeil
Automotive Products, Ltd.. It represents the state-of-the-art of today's technology for
battery charging. Please read these operating instructions carefully before operating the
WeatherTech
SmartCharge 200.
®
IMPORTANT SAFETY INSTRUCTIONS
California Proposition 65
WARNING: This product contains chemical known to the state of California to cause
cancer or reproductive toxicity.
SAVE THESE INSTRUCTIONS
1.
contains important safety and operating instructions for battery charger models
WeatherTech
2.
When charging, batteries can emit explosive gases, therefore it is essential
to prevent ames and sparks. The charger is designed for charging lead-acid
batteries from 2 to 90Ah. Do not use for any other purpose.
3.
Always provide good ventilation when charging.
4.
Use of an attachment not recommended or sold by the battery charger
manufacturer may result in a risk of re, electric shock or injury to persons.
5.
To reduce risk of damage to the electric plug and cord, pull by the plug rather than
cord when disconnecting charger.
6.
An extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result in a risk of re and electric shock. If an
extension cord must be used, make sure that: a) Pins on plug of extension cord
are the same number, size and shape as those of plug on charger; b) Extension
cord is properly wired and in good electrical condition; and c) Wire size is large
enough for ac ampere rating of charger as speci ed in "technical data".
7.
Do not operate charger with damaged cord or plug – return the charger to the
place where purchased.
8.
Never operate the charger if it has received a sharp blow, been dropped or
otherwise damaged in any way; take it to a quali ed serviceman.
9.
Do not disassemble charger; take it to a quali ed serviceman when service or
repair is required. Incorrect reassembly may result in a risk of electrical shock or
re.
10.
To reduce risk of electric shock, unplug charger from AC outlet before attempting
any maintenance or cleaning. Turning off controls will not reduce the risk.
SmartCharge 200 is a primary switch mode battery charger with
®
SmartCharge 200.
®
– This manual
Hide quick links:
Advertisement
Table of Contents
